2. FSB
3. Bios revision
4. Cooling
5. Board Revision
6. Modifications
7. Operating System
8. System specifications (Installed hardware, etc.)
9. Power supply (Make, Model and Wattage)
==============================================================================================
1: (Need to check this)
==============================================================================================
2: 90MHz 80Mhz
==============================================================================================
3: RU
==============================================================================================
4: Globalwin Fop32/38 Heatsinks with the fans off my Xeon wind tunnels (60mm 6000RPM ish) and a 486 fan on the chipset. The room was cold as the window was open, and the bios showed the temps to be 26degC, May look at water cooling if it was the cold room which helped make it post at this speed.
Intel P3 heatsinks and fans, but might go back to the above setup soon.
==============================================================================================
5: (Need to check this as well)
==============================================================================================
6: EC10
==============================================================================================
7: Windows 2000 Pro. I don’t know if it will boot into windows yet as it corrupted the install at a lower fsb when the PCI bus speed didn’t agree with the controller. I think it was when it was at 40 or 42 ish, but it booted to the same point it would boot to at standard speed... I'll cross my fingers and hope it works better tonight. after reinstalling.
Mandrake 10
==============================================================================================
8: PCI Stealth Video 2500 / PCI Intel Pro 100 NIC / 256MB Crucial 133 RAM / 8gb Seagate Harddrive.
AGP Voodoo 3 / PCI Intel Pro 100 NIC / 256MB Crucial 133 RAM / 60Gb IBM Deskstar / Sound Blaster Live!
==============================================================================================
9: 300Watt Unbranded cheap thing
==============================================================================================
It also posted at 91 and 92fsb but crashed when detecting the drives, I would up the voltage a little more but I’m at the current max (2.3V) but I’ve read some where on here that this can be increased, Ill have to go find that next. (Not sure on trying higher voltage what is the highest people have gone?)
2 years ago these chips would only just post at 600, so I’m not sure if its because it has so little hardware in compared to what it had in back then or if its just that the chips have been burnt in more.
Another thing I noticed, as soon as I went over 600Mhz, the bios still showed it as 600Mhz until I hit 650Mhz then it stayed at that from then on, is there any way to fix this?
Only other thing I have to say is wahoo! As I wasn’t expecting to get them this high.
![Shocked :shock:](./images/smilies/icon_eek.gif)
David