Hello everybody,
I bought a seagate 200Gb ... and I got the surprise to get only 137Go. So, after searching a little on bp6.com, I bought a Promise Ultradma133 which works fine.
BUT (of course, there is a but) I have many problems. My question is :
On which slot should I plug my Promise ?
At the moment, it is on PCI2, but I have the following conflicts on IRQ 18 :
IRQ 18 WinXP Promise Ultra133 TX2 (tm) IDE Controller
IRQ 18 Contrôleur d'hôte ouvert PCI vers USB NEC
IRQ 18 Highpoint Technology Inc. HPT366 Ultra DMA 66 Controller
IRQ 18 Highpoint Technology Inc. HPT366 Ultra DMA 66 Controller
Thanks in advance for your help (other questions may follow ...
)
Clément.
Installing Promise UltraDma 133
-
- Board Admin
- Posts: 1395
- Joined: Wed Jul 24, 2002 7:39 am
- Location: Lincoln, NE USA
- Contact:
Re: Installing Promise UltraDma 133
This may be normal. Which version Windows are you running? Is ACPI enabled in the BIOS?clement wrote:Hello everybody,
I bought a seagate 200Gb ... and I got the surprise to get only 137Go. So, after searching a little on bp6.com, I bought a Promise Ultradma133 which works fine.
BUT (of course, there is a but) I have many problems. My question is :
On which slot should I plug my Promise ?
At the moment, it is on PCI2, but I have the following conflicts on IRQ 18 :
IRQ 18 WinXP Promise Ultra133 TX2 (tm) IDE Controller
IRQ 18 Contrôleur d'hôte ouvert PCI vers USB NEC
IRQ 18 Highpoint Technology Inc. HPT366 Ultra DMA 66 Controller
IRQ 18 Highpoint Technology Inc. HPT366 Ultra DMA 66 Controller
Thanks in advance for your help (other questions may follow ...
)
Clément.
I have my Promise card in slot 3. You may experience problems, however, if you use slot 3 and the HPT. I never use the HPT.
Like BP6.com? Not a member?
Then why the hell not? It's great!
-> BP6.com Membership <-
Then why the hell not? It's great!
-> BP6.com Membership <-