I just have one, question... does anyone have a diagram of vid pin trick for those 366's ???
and did anyone tried to get more voltage like this on these celerons? I mean more than 2.3V
I used once the program "rise of BP6" or something and managed to get them running at 2.45V... after like 45minutes of trying, cause the mobo just is not cold-booting so easily with more voltage...
Vid Pin Mode for mendocinos??
Vid Pin Mode for mendocinos??
Dual C366@550MHz 1.90V (History)
yet single PIII-S 512Kb L2 cache at 1400MHz@700MHz
BP6 (not modded yet)
256MB PC133 C2
GF4Ti4200-8x
Maxtor 2x60Gb - all on promise ATA133
Lite-On LTR 40125S@48125W!!!
Plus P4 system
yet single PIII-S 512Kb L2 cache at 1400MHz@700MHz
BP6 (not modded yet)
256MB PC133 C2
GF4Ti4200-8x
Maxtor 2x60Gb - all on promise ATA133
Lite-On LTR 40125S@48125W!!!
Plus P4 system
-
- Board Admin
- Posts: 1395
- Joined: Wed Jul 24, 2002 7:39 am
- Location: Lincoln, NE USA
- Contact:
yeah, that was the hardware method.
If you know the same method for P4 Norhtwood. Drop me a link also - I will get my GB board in 2-3 weeks
If you know the same method for P4 Norhtwood. Drop me a link also - I will get my GB board in 2-3 weeks
Dual C366@550MHz 1.90V (History)
yet single PIII-S 512Kb L2 cache at 1400MHz@700MHz
BP6 (not modded yet)
256MB PC133 C2
GF4Ti4200-8x
Maxtor 2x60Gb - all on promise ATA133
Lite-On LTR 40125S@48125W!!!
Plus P4 system
yet single PIII-S 512Kb L2 cache at 1400MHz@700MHz
BP6 (not modded yet)
256MB PC133 C2
GF4Ti4200-8x
Maxtor 2x60Gb - all on promise ATA133
Lite-On LTR 40125S@48125W!!!
Plus P4 system