I have one 5x5x4cm aluminum heatsink/fan combo sitting on top of the north
![Smile :)](./images/smilies/icon_smile.gif)
I was thinkking acually of putting there after soldering one waterblock with custom size TEC
Any idea at which speed should I cut ceramics with my dremel and which head shouls I use for it not to crack??
![Twisted Evil :twisted:](./images/smilies/icon_twisted.gif)
You know, those 226W tecs are a bit expensive and I doubt one of them would fit there
but that is after the soldering of course
sorry for little updates... just after the job I don't get too much free time
Oh here you have some photos of how does the CPU/adapters sandwich look like. and there you see I cut the trace on Neo twice just to be sure
By the way, I have put on the top the heatsinkfan from powerleap which came with neo. you do not need any paperclips - it fits perfectly with one adapter extra in between
![Smile :)](./images/smilies/icon_smile.gif)
You do not have the required permissions to view the files attached to this post.
Dual C366@550MHz 1.90V
![Smile :)](./images/smilies/icon_smile.gif)
(History)
yet single PIII-S 512Kb L2 cache at 1400MHz@700MHz
BP6 (not modded yet)
256MB PC133 C2
GF4Ti4200-8x
Maxtor 2x60Gb - all on promise ATA133
Lite-On LTR 40125S@48125W!!!
Plus P4 system