What is JP1 on the motherboard?
JP1 is for Power on after Power failure. Mainly used for remote servers. This allows the system to Reboot by Itself after any power failure. Set jumper on switch to pins 1-2 for Power on after Power failure. Default position for jumper on switch is pins 2-3. Setup your BIOS accordingly!
JP1 is located between the WinBond and IO/ACPI chips. Almost in-line with PCI Slot4.
Most of the above information comes from one of the first BP6 masters, Jr Leduc. Thanx, Jr. Where ever you are...
Frequently asked questions about the BP6.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests