headed to warp 9 (I hope)

Batch codes, RAM specs, BIOS settings, etc..
Post Reply
jaybird
Posts: 301
Joined: Tue Jul 30, 2002 9:21 pm

headed to warp 9 (I hope)

Post by jaybird » Sat Mar 25, 2006 10:14 am

Just got my "new" 1100E from "down-under" and I flashed my BIOS to the BP6RV128.BIN version a few minutes ago. I now have a working pair of 1100E's again :) !

V1.0, Rev. .40 board has all required changes except for wiring on back side of ZIF sockets.

I have been testing this BIOS/board combination for stability pushing the 366's to the limit, still stable @ 572.

Will keep all posted.

Here we go again!

Regards,

jaybird

jaybird
Posts: 301
Joined: Tue Jul 30, 2002 9:21 pm

Post by jaybird » Sun Mar 26, 2006 4:09 pm

To make a long strory short, she "blew a motor" with out even getting out of the pits.

Turns out one of my PIII's was bad and I didn't even know it. I now have only 1 good PIII and 2 good NEO's.

Did hit 1210 mhz with one PIII, worked in either zif socket.

Back to the drawing board!

davd_bob
Confused
Posts: 1043
Joined: Fri Feb 13, 2004 2:30 am
Location: Houston, TX

Post by davd_bob » Mon Mar 27, 2006 1:11 am

NOOOOOO!!! :shock:
Not another 1100 P-III down the drain :headsmash:
There are *almost* no bad BP6s. There are mostly bad caps.

No BP6s remaining
Athlon 2800
Sempron 2000
ViaCPU laptop with Vista.(Works great after bumping ram to 2Gig)
P-III 850@100

Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests