BP6 - Revision 1.0 => faster CPU possible?

vgoraz · Post by **vgoraz** » Sun Apr 20, 2003 10:54 pm

wow where to begin...
ummmm just read through alot of these forums for yourself and also the articles on this site. there is a bios download section at:
http://www.bp6.com/board/dload.php?action=category&id=1

the faq section is here
http://www.bp6.com/board/viewforum.php?f=48

that should help you get on your way. if you have anything else in particular you wish to ask, then yeah just go ahead and do so in the relevant sections of the forum and we will give some specific advice and information

hyperspace · Post by **hyperspace** » Mon Apr 21, 2003 7:40 am

What happens when you try to run two processors?

kuun · Post by **kuun** » Mon Apr 21, 2003 1:52 pm

ok find the RU bios flash (not sure where it is)

once you do that then we'll need to help you overclock (you need to adjust CPU voltages and stuff)

then we'll see about finding you some faster CPU's (466's seem to be the best to overclock without any mods)

or if you can or want to you can do what im going to do and modify your board and make it so you can run some P3's in there

Kuun

p.s. what is your mother language? i will try to get a translation of what i want to say so you can understand it better

InactiveX · Post by **InactiveX** » Mon Apr 21, 2003 2:17 pm

kuun wrote:466's seem to be the best to overclock without any mods

366s, surely?

kuun · Post by **kuun** » Mon Apr 21, 2003 2:20 pm

from what i've observed 466's have reached higher FSB speeds and are more stable at those speeds

i may be wrong.. correct me if i am

InactiveX · Post by **InactiveX** » Mon Apr 21, 2003 3:09 pm

Anything in the 300-366 range stands a good chance of reaching 100MHz FSB, where the PCI and AGP speeds are in spec.

To push a 466 to 100MHz FSB would give you a clock speed of 700MHz - which is extremely unlikely.

vgoraz · Post by **vgoraz** » Mon Apr 21, 2003 5:57 pm

my 366s cant get past 85mhz bus, it will post fine well up into the 100 range and windows appears to attempt to want to start, but well it never does.
then again i have not done any mods or anything with it nor increased the voltage to much, so well i dont know really. i guess i could decide now to push this board to its full limits (hopefully my poor server doesnt die)

kuun · Post by **kuun** » Mon Apr 21, 2003 6:37 pm

oh

hhe well my 500's won't go further than 75MHZ

if i try to hit 80MHZ ... well they spaz out

Kuun

InactiveX · Post by **InactiveX** » Tue Apr 22, 2003 12:29 am

vgoraz wrote:my 366s cant get past 85mhz bus...
then again i have not done any mods or anything with it nor increased the voltage to much

I have overclocked my 366s to 500MHz reliably for ages with the VCores set at 2.1V. Try it!